Announcement

Collapse
No announcement yet.

Grad present to granddaughter

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Grad present to granddaughter

    Walnut backing with 1/8" corian letters and cap and year of grad .littlr ahead of myself but had the materials so what the heck. "Get h" done".Now place where I "ll never find .Only year ahead.

    Cut with FD #3 blade

    comments welcome and thanks for the look see and the pattern.

  • #2
    Nicely done...
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment


    • #3
      Croaker

      I have been trying to find corian. Looked at HD, Lowes, Menards. Is it known by any other name? Your projects look great.

      Larry

      Comment


      • #4
        Larry try scraps from counter shop. They use it for tops and back splash on the walls.
        I just ask and they give me all I can use plus some.

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • handibunny
          Reply to EX dust collection holes screwed up a project.!
          by handibunny
          Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
          Today, 09:21 AM
        • Bill Wilson
          Reply to EX dust collection holes screwed up a project.!
          by Bill Wilson
          I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
          Today, 09:06 AM
        • cwmagee
          Reply to EX dust collection holes screwed up a project.!
          by cwmagee
          Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
          Today, 08:40 AM
        • Rolf
          Reply to EX dust collection holes screwed up a project.!
          by Rolf
          That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
          Today, 07:28 AM
        • handibunny
          Reply to EX dust collection holes screwed up a project.!
          by handibunny
          Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
          Today, 06:21 AM
        Working...
        X