If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁
Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
I'll talk about this specific "slice" of your question, with more detail that you probably want or need.
Most Tilting head saws do come from the same Taiwan factory, except Excalibur. So what happened with Excalibur was . . . General got bought by a Chinese investor, some China/Taiwan...
It doesn’t matter whether the saw table tilts or the saw arm tilts. Either can be used for any project cut at an angle, and there’s a learning curve for each.
I actually prefer the tilting table because the blade remains vertical. I find that at really steep angles, like 40 or 45 degrees,...
Comment