Announcement

Collapse
No announcement yet.

First Portrait

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • First Portrait

    My first portrait of my grand daughter. On 1/6/12 I asked for help on this pattern. Don and Ron submitted patterns. Thanks to Don (joleet) for this one. Hope to get to the other one soon.

  • #2
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • handibunny
      Reply to EX dust collection holes screwed up a project.!
      by handibunny
      Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
      Today, 09:21 AM
    • Bill Wilson
      Reply to EX dust collection holes screwed up a project.!
      by Bill Wilson
      I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
      Today, 09:06 AM
    • cwmagee
      Reply to EX dust collection holes screwed up a project.!
      by cwmagee
      Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
      Today, 08:40 AM
    • Rolf
      Reply to EX dust collection holes screwed up a project.!
      by Rolf
      That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
      Today, 07:28 AM
    • handibunny
      Reply to EX dust collection holes screwed up a project.!
      by handibunny
      Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
      Today, 06:21 AM
    Working...
    X