Announcement

Collapse
No announcement yet.

John Wayne

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • John Wayne

    Final one for the weekend. Pattern by Scrollzilla.
    Linda

  • #2
    Good job, Linda
    Chuck D


    When a work lifts your spirits and inspires bold and noble thoughts in you, do not look for any other standard to judge by: the work is good, the product of a master craftsman.
    Jean De La Bruyere...

    l
    Hegner 18, Delta p-20, Griz 14 inch Band saw

    Comment


    • #3
      looks great linda
      not doing much
      and busy doing it


      having fun making sawdust.


      http://www.customcutz4you.webs.com/

      Comment


      • #4
        Fine job Linda , sure can tell who it is ................
        Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

        Comment


        • #5
          Excellent cutting of the Legend.

          Comment


          • #6
            Excellent cutting Linda, he was my favorite. Edward
            http://www.scrollsawer.com/gallery/s...00&ppuser=6384

            Comment


            • #7
              another nice cutting Linda
              Dennis

              Comment

              Unconfigured Ad Widget

              Collapse

              Latest Topics

              Collapse

              • handibunny
                Reply to EX dust collection holes screwed up a project.!
                by handibunny
                Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
                Today, 09:21 AM
              • Bill Wilson
                Reply to EX dust collection holes screwed up a project.!
                by Bill Wilson
                I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
                Today, 09:06 AM
              • cwmagee
                Reply to EX dust collection holes screwed up a project.!
                by cwmagee
                Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
                Today, 08:40 AM
              • Rolf
                Reply to EX dust collection holes screwed up a project.!
                by Rolf
                That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
                Today, 07:28 AM
              • handibunny
                Reply to EX dust collection holes screwed up a project.!
                by handibunny
                Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
                Today, 06:21 AM
              Working...
              X