Announcement

Collapse
No announcement yet.

Veins

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mick Walker
    replied
    Trackman, one other thing, if the veins are very close to each other such as a grill on a car. Stagger the entry holes so they are not next to each other.

    Leave a comment:


  • Trackman
    replied
    Thank you very much for the links Chuck! These will be very helpfull. I like your idea of making 2 holes side by side, makes sence.

    Leave a comment:


  • ChuckD
    replied
    Trackman, Here are a couple of previous post on veins. Maybe they will answer your question.

    http://www.scrollsawer.com/forum/beg...-saw/35834.htm

    http://www.scrollsawer.com/forum/fre...aits/29153.htm

    Good luck

    Leave a comment:


  • Trackman
    started a topic Veins

    Veins

    I have a pattern that has a lot of veins in it that don't start somewere and end up in a vein. There is just the vein. My question is were is the best spot to drill the hole, at the end, in the middle or somewere else on the vein?
    I have the smallest bit that is to be used with a #3 blade should I fade into an out of the hole? Thanks

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

Working...
X