Announcement

Collapse
No announcement yet.

Lawyers Cross

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lawyers Cross

    Here's the Lawyers Cross i cut out this morning for a customer from my show..
    It's another Sue Mey design of course..And 18" tall.
    Michael.....Indy..........
    "Dream what to cut, Cut what you dream"
    On Facebook
    https://www.facebook.com/pages/Custo...g/177349793474

    "EX-21 is my saw for life"

  • #2
    really turned out nice, good work
    "The Scrollin Skeeter"

    "There's nothin like the smell of fretwork in the morning"

    Comment


    • #3
      Extremely nice and clean cutting, must practice, practice practice hehe, well done looks great.
      The Journey Is Everything.

      http://www.sunlion-pyrography.co.uk/

      My Google+

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
        Today, 09:21 AM
      • Bill Wilson
        Reply to EX dust collection holes screwed up a project.!
        by Bill Wilson
        I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
        Today, 09:06 AM
      • cwmagee
        Reply to EX dust collection holes screwed up a project.!
        by cwmagee
        Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
        Today, 08:40 AM
      • Rolf
        Reply to EX dust collection holes screwed up a project.!
        by Rolf
        That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
        Today, 07:28 AM
      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
        Today, 06:21 AM
      Working...
      X