Tweet
Here are some of the Christmas Ornaments I made this year.
Linda
Linda
-
-
Those all look great. I love cutting these. Bobby -
Tis the season huh? I have been cutting em too. You did some really good work there.Pacifism is great, as long as everyone is participating.
StephenD
The Southern Arizona Woodturners Association
Desert Woodcrafters
Grandpa for the 7 most amazing children.Comment
-
Very good ornaments.
I really like them.
Wher are some of the patterns from?Last edited by Terry Murphy; 12-05-2011, 08:53 PM.
It's all fun
Terry
Craftsman 18"
Delta 46-460 lathe
________________________
https://www.facebook.com/SillyLillyBowsAndMoreComment
-
Busy little bee, aren't you? Great job!"Live as though Christ died yesterday, arose this morning, and is coming back tomorrow."Comment
-
Totally awesome Linda! DonDonComment
-
Very nice!!DeWalt 788Comment
-
Very nice clean work.
If you don't mind me asking, what material and thickness of same have you used there?, they look realy nice and crisp.
Steve/SunlionComment
-
Thanks for all the comments. I use 1/8" baltic birch, paint them white and then spray glitter on them.
LindaComment
-
Nice work Linda.
I like to cut ornaments.
BobDelta P-20 & Q-3
I wondered why the baseball was getting bigger. Then it hit me!Comment
-
You have been busy too Linda .......pretty work ......love Tree Ornaments............MBUsually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }Comment
-
Sorry Linda did not get back to say thanks for the info (hehe lost the post).
I must try some thinner work like that. I have used 6mm Birch faced ply over the years for my pyro work, never tried the 3 ply as yet (next size down over here in sheet form I think).
I tend to buy sheet, have them cut into eight pieces for easy transport and cut to size in my shed as required. Down to my last 4'x 2' piece atm on my last sheet, so may look at trying thinner board next visit to a local supplier.Comment
Comment