Announcement

Collapse
No announcement yet.

The Way Cross

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • The Way Cross

    Here it is cut out of 1/2'' maple. Bobby
    Last edited by Scrollriffic; 05-09-2014, 12:00 AM.

  • #2
    Just beautiful! Don
    Don

    Comment


    • #3
      Fine job Bobby ...........
      Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

      Comment


      • #4
        Nice job Bobby
        Dennis

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • Jo Labre
          Reply to Joining the new tool frenzy
          by Jo Labre
          I cut a bunch of chakte viga and leopardwood pieces for the Viking project and the blade seems pretty good yet. I imagine if I were to only cut softer hardwoods (?) the blade would last quite a long time. Still - $25.00 is a lot more than the cost of standard scroll saw blades....
          Today, 02:36 PM
        • old fa_t
          Reply to Old,,,,but new here
          by old fa_t
          The room was supposed to be storage but it's my office? now with a roll top desk and a barristers bookcase.which I built when I was able.
          Today, 01:55 PM
        • Rolf
          Reply to Joining the new tool frenzy
          by Rolf
          Very nice! I really like your setup especially for the dust collection. I would have to figure out a way to re-weld the blade.
          And Oh to have wall space and organizational skills!
          Today, 09:55 AM
        • Rolf
          Reply to Old,,,,but new here
          by Rolf
          Welcome! As the others have said, lots of support and knowledge here ready to be shared.
          Is the 6 x10 your workspace or your entire apartment. ?
          Today, 09:34 AM
        • Rolf
          Reply to Log slice ornaments
          by Rolf
          Most of the cut outs were done with the scroll saw.
          Karl I have a couple of power carvers. The classic Dremel with a flex shaft I then bought a Ram Power carver, they both use 1/8 shank bits. I have a bunch of carbide cutters from when our Printed circuit board facility at work was dismantled....
          Today, 09:29 AM
        Working...
        X