If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just finished this today. Made it for a friend I used to work with. She wants it for her dad. It's a Steve Good good pattern, "The Chopper". I made it hang instead of stand up. Don
Thanks - To make the box joints I used a 1/2" straight bit and my Incra jig. I used the little right angle sled that comes with the Incra fence, but now that I have the miter slot, I'll be getting or building a good coping sled....
I cleaned some space on my workbench to set this thing up and then had to clean some more space. I read about the 54X45CM size, but I guess I wasn't really thinking about how big it is. I put an 18 inch ruler in for scale in the "built" picture.
Tweet
...
Comment