Announcement

Collapse
No announcement yet.

can some one help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • can some one help

    Has any one seen a pattern of this, if so where can I get it?

    Thanks
    Attached Files
    Last edited by Pajaro; 10-01-2011, 11:09 PM.


    www.pajarostudiowns.com
    Excalibur EX-21 fanatic
    One of the Chosen few



    "The Rumors Of My Demise Have Been Greatly Exaggerated......I am retired!!!!!!!".


  • #2
    Is there an attachment?
    Theresa

    http://WoodNGoods.weebly.com

    http://woodngoods.blogspot.com

    Comment


    • #3
      Nothing showing but a red x for me.
      Mick, - Delta P-20

      A smile is a small curve that straightens everything out.

      Comment


      • #4
        Michelangelo The Creation Of Adam painting. I made a couple of patterns for you if you can use them. See what you think. Hope it helps.
        ha i guess i only saved one, oh well, i liked this one better anyway! lol

        Russell
        Attached Files

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • will8989
          Reply to Shrink wrap systems
          by will8989
          Well, I used to get my shrink wrap rolls from AC Moore, and just used the last roll😟. I use a heat gun but lately and only shrink the Sealife puzzles to keep the pieces in place. I only use it on puzzles because of my display board otherwise I would have broken pieces all over the place. Also easier...
          Today, 09:49 PM
        • will8989
          Reply to Bruce, the one on probation
          by will8989
          He’s gotten me through some pretty tough times and always has my back so It’s the least I can do. Good thing I had the freezer stocked! That has been a time saver. I made a pot of chili on Sunday and got 6 meals out of it! As for payback, I’m getting a new shed in the spring! I had to do my flap...
          Today, 09:32 PM
        • will8989
          Reply to Sundays market
          by will8989
          We did. I only went $40 over budget. I got a 73” x 12” x 3/4” curly cherry for $55. Just needs to be run through the sander and cut to size. It’s a pinkish cherry and is so pretty. A piece of deep red redwood, 2 pieces of walnut each about 12” wide. Good haul.
          Today, 08:56 PM
        • Jim McDonald
          Reply to Interesting pallet
          by Jim McDonald
          I have harvested some very interesting specimens in the last 10 years. Bookmatched ash that was absolutely beautiful; red oak, maple, some spalted "something" and more.
          But since most of the cross boards on pallets are 3 to 4 nches wide and 3/8" to 5/8", I have few uses for...
          Today, 08:17 PM
        • Quartz43
          Reply to New tools
          by Quartz43
          I have an implanted spinal cord stimulator to help with back pain. They also have warnings about welding. I could not get one when I was working in an electric furnace steelmaking shop as the electrodes were over 1000 amps and volts. I have also decided to stay away from welding as I just do not...
          Today, 03:40 PM
        Working...
        X