Tweet
An Alex Fox pattern he lists as C12. I used 1/4" Baltic Birch plywood 10" square. Cut on the Pegas scroll saw using Pegas #1 MGT blades. After gluing, two coats of spray Lacquer clear gloss. Comments welcome.
-
Denny
ArtCrafters in Dayton, TN -
I made that awhile back out of 1/4 cherry. Came out great but drove me crazy gluing up. Of course, that was a short ride!!
Betty
"Congress needs to realize it is a government of the people, by the people and for the people. Not of the people, by the people and for Congress." - Dr. Benjamin Carson, Pediatric Neurosurgeon, Johns Hopkins Hospital -
Betty, I enlarged the pattern by 30% to fit on 10" square stock.Originally posted by will8989 View PostDenny
ArtCrafters in Dayton, TNComment
-
Nice work. I truly admire all the projects that you share and I truly envy the fact that you finish what you start. What is your secret?Scott
Creator of fine designer sawdust.Comment
-
That is a beauty.! This design with its 7 deg rotation between layers is why I made my alignment jig.
Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw AssociationComment
-
Very nice Denny you are raising the bar all the timeComment
-
Thanks Scott. I try to finish most of my projects, but there are a few still sitting around.Originally posted by NC Scroller View PostDenny
ArtCrafters in Dayton, TNComment
-
Thanks Rolf. A jig would sure be helpful.Originally posted by Rolf View PostThat is a beauty.! This design with its 7 deg rotation between layers is why I made my alignment jig.Denny
ArtCrafters in Dayton, TNComment
-
Thanks Pete. Yu raised the bar with your latest bowl.Originally posted by scrollerpete View PostDenny
ArtCrafters in Dayton, TNComment
Comment