If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
A spontaneous purchase bit me in the butt. I bought this disc from woodcraft https://www.woodcraft.com/products/w...mounting-plate with the primary purpose of using it to fine tune my table saw alignment. It is advertised as sanding / calibration disk! I installed it...
I think you will be very pleased with how quiet it is and the filter maintenance is simple.
It is the same size as the WEN unit that I hung from my ceiling yesterday. I found a space in my main work area where I wont hit my head on it.
It is right under our great room floor. I was worried...
Tweet
Comment