Announcement

Collapse
No announcement yet.

Tribal Box

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tribal Box

    This was my project for the weekend. It's one from Steve Good and it's made from poplar and pine.
    Attached Files
    It's only a mistake if someone saw you do it.

    It's not about what saw you drive. It's about the skill you drive it with.

    Jim

  • #2
    That is very pretty. I saw that on Steve's site and now that I've seen yours I may make one. You did a very good job on it.
    Fran

    Comment


    • #3
      Nicely Done. Thanks for sharing it with us.


      DW
      Life is hard. It is even harder when you are being stupid.
      John Wayne

      Comment


      • #4
        Very nice job.
        Excuse my English, I go through a translator
        Jean-Jacques
        http://tour-dec.fr/

        Comment


        • #5
          Very nice Box WF. Clean lines and a very interesting lid.

          Mike

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • markdavd
            Reply to Frustrated
            by markdavd
            When a blade slips out, the tendency is to tighten it more. Make sure you haven't over-tightened the clamp forcing the sides apart. Most OEM clamps are made from soft aluminum so once it starts they will continue spreading and it will be near-impossible to keep the blades in place.

            I've...
            Yesterday, 10:03 AM
          • Sandy Oaks
            Reply to Frustrated
            by Sandy Oaks
            Blade slippage is a function of the blade clamp holder and or the set screw and thumb screw with swivel.
            Yesterday, 09:40 AM
          • NC Scroller
            Reply to Frustrated
            by NC Scroller
            Tricia what saw do you have? Does the blade slip or it just won’t tighten?
            Yesterday, 08:01 AM
          • wjbclocks1
            Reply to Frustrated
            by wjbclocks1
            Are yoou sure that your not puting the blades to far up in the top clamps,. ( l learned thst the hard way)...
            Yesterday, 07:46 AM
          • cwmagee
            Reply to Frustrated
            by cwmagee
            Have you tried to rough up the thumb screws tips? How old are the blade clamps? may be time to replaced them.
            Yesterday, 06:48 AM
          Working...
          X