Announcement

Collapse
No announcement yet.

Heart Shaped Box

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Heart Shaped Box

    This is a Steve Good pattern. I used Oak and Poplar. It was fun project. Going to go ahead and make a lid for it.
    Attached Files

  • #2
    Nicely done. Thanks for sharing it with us.

    DW
    Life is hard. It is even harder when you are being stupid.
    John Wayne

    Comment


    • #3
      Nice cutting Okie.
      Merle
      SSG US Army Retired.
      [email protected]
      http://www.etsy.com/your/listings

      Comment


      • #4
        Looks cute!
        DeWalt 788

        Comment


        • #5
          You did a very nice job of cutting on that one...I also had fun making it.
          Hawaiilad
          Larry

          Comment


          • #6
            I made a lid for the Heart Box. Didn't have any Oak so I used Plywood and stained the little hearts and flowers dark mahogany
            Attached Files

            Comment

            Unconfigured Ad Widget

            Collapse

            Latest Topics

            Collapse

            • dwssr2
              Reply to hegner 2"
              by dwssr2
              I have no idea what the measurements of the 18" table are, I can give measurements of the poly max and the 14"....
              Today, 05:22 AM
            • MidMich324
              Reply to hegner 2"
              by MidMich324
              Just Wondering...

              Is the table size on the 22" hegner saw as on the 18" hegner saw?

              With the 22" inch one you get 4 more inches of depth of cut but do you also get a few more inches of table?
              Yesterday, 09:30 PM
            • will8989
              Reply to Spring Issue
              by will8989
              I had to fool around with copying and taping a pattern again today. This wasn’t as bad as the fish, but still a pain. I use rapid resizer. Scan a pattern, put in size I want and it prints it out. If more than one page, it numbers each page at the top and I tape them together. Had the fish pattern...
              Yesterday, 09:28 PM
            • millwab
              Reply to Peanuts #1
              by millwab
              Rolf, I cover it with clear contact paper (comes off clean without leaving a residue) and draw a grid for the direction I want to cut (ie horizontal or diagonal) to keep the rows even. The rest is all freehand....
              Yesterday, 02:51 PM
            • Don in Brooklin On
              Reply to Spring Issue
              by Don in Brooklin On
              Rolf

              I use acrobat reader. The poster feature will enlarge and if it goes to multiple pages it will put in cut marks. Even if the page is over letter size it will spread to multiple pages at 100%.

              If it is in PDF form you can open with Inkscape or GIMP and select what you...
              Yesterday, 01:48 PM
            Working...
            X