Announcement

Collapse
No announcement yet.

Heip with box

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Heip with box

    Ok so I wanted to gett rid of end grain showing on side of boxs,So I gluded up some 3/4 by 2" in a square with conters at 45%. then cut it round. I s there any other way to this? If you don't have 2" wood. Lance
    Attached Files

  • #2
    You would need to make a raft that was all end grain. Cut your board into 1 inch wide strips. The top and bottom get glued together leaving the end grain exposed. Cut your bowl from this glue up and you should have no end grain showing on the sides only the bottom of the bowl.

    DW
    Life is hard. It is even harder when you are being stupid.
    John Wayne

    Comment


    • #3
      Thanks for the help DW. I'll have to gaive that a try. Lance

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • jim_mex
        Reply to Home remodeling update - 28 August
        by jim_mex
        24 Oct - Home 'make-over completed!!!

        Hi again all – time flies when you are busy and Norma and I have certainly been that the past couple of months since we embarked on our home 'total make-over' project but the good news is the work is now complete and we spent the past week moving back
        ...
        Today, 12:39 PM
      • scrollerpete
        Reply to Dog Puzzle - Aussie
        by scrollerpete
        You did a fantastic job Denny, I’m sure you will have an happy customer...
        Today, 12:33 PM
      • Sandy Oaks
        Dog Puzzle - Aussie
        by Sandy Oaks
        This is a custom order request. The pattern is by Harvey Byler purchased from WoodCraftByScott.com. I enlarged the pattern by 10%. Cut at home on the EX21 using FD UR #5 blades. The wood is Poplar approximately 7" x 9". Sanded with the Sand Flee and dipped in Shellac diluted 50% with...
        Today, 10:43 AM
      • Rolf
        Reply to I admit it... I splurged on a new "toy"
        by Rolf
        Quartz. What are you not certain of?
        I needed to make a couple of custom sized Octagonal replacement windows, I wanted the most precision. I don't remember where I bought it. If I had seen the bi-directional Incra 1000 I probably would have bought it instead. With the 2000 you have to choose...
        Today, 09:08 AM
      • Rolf
        Reply to Carved Fretwork Pumpkin
        by Rolf
        Love every bit of it! The lighting really makes it pop. Would you mind sharing the source for the lights that you used?...
        Today, 08:55 AM
      Working...
      X