If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Pattern by Steve Good slightly modified by changing the wood thickness. White pine was used and then stained with ta water based white stain then sealed with lacquer and then lightly hit with silver glitter spray on the wings.
Has anyone replaced the eccentric on the Hegner scroll saw or made any adjustments to this part.
I bought an used Hegner m22 and it vibrates at about 3/4 speed. Maybe I'm just over thinking this problem, last year I purchased a multi cut 3/25 inch Hegner it is a single speed and it runs like a...
Tweet
Comment