setting blade

[Guest]

What is the best way to set the blade at a true ninety
degrees to table.

[plain_ol_ed]

Re: setting blade

I use a small square (about 4' on a side).

[jttheclockman]

Re: setting blade

I also agree that is the way I do it. Use a small machinist square and check both sides of the blade and you can't go wrong. JTTHECLOCKMAN

[3_M]

Re: setting blade

If you don't have a little square, take a piece of scrap at least 3/4' thick and cut about 1/16' into the wood. You can do two things. Turn it over and try if it fits in the kerf or you can try if it fits in the back of the blade, without turning it over.
Mike M

[Hi_Ho_Sliver]

Re: setting blade

Very good tip Mike! thanks

[Guest]

Re: setting blade

Thanks for the replys they are good tips that I will use.