Announcement

Collapse
No announcement yet.

had it now

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • had it now

    saw going back i think onlly changed blade 4 times, an now it wont tighten for god sake, they sent me 2 this morning they come, i really fed up, they did say i could send saw back if i wasnt happy,,,,what the hell is happening with me an these dam blade holders, any comments what i should do ???

  • #2
    If it were me (and it's not) I'd send it back and buy an Excalibur.

    Just my 2 cents
    Experience is something you don't get until just after you need it.

    Comment


    • #3
      What kind of saw is it??
      Bob making sawdust in SW Louisiana
      with a EX-21

      Comment


      • #4
        awvfs variable speed fretsaw 700153 from axminster

        Comment


        • #5
          that would be the saw I'm saving up to buy the EX-21 is a top of the line so not going cheap on my next saw.Jerry
          Don't worry be scrolling

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • axor
            Reply to Shawl pins
            by axor

            Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
            Today, 03:21 PM
          • handibunny
            Reply to EX dust collection holes screwed up a project.!
            by handibunny
            Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
            Today, 09:21 AM
          • Bill Wilson
            Reply to EX dust collection holes screwed up a project.!
            by Bill Wilson
            I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
            Today, 09:06 AM
          • cwmagee
            Reply to EX dust collection holes screwed up a project.!
            by cwmagee
            Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
            Today, 08:40 AM
          • Rolf
            Reply to EX dust collection holes screwed up a project.!
            by Rolf
            That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
            Today, 07:28 AM
          Working...
          X