Announcement

Collapse
No announcement yet.

Axminster Blade Clamp Grub Screws

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Axminster Blade Clamp Grub Screws

    well thats me done till new clamps come , not even bin on it that long oh well

  • #2
    Have patience, it will be worth the trouble when you get it up and running.

    Comment


    • #3
      aww thanks okie i was really enjoying it , not good at it but hey i might be one day

      Comment


      • #4
        We've all been there. Try not to lose heart.

        Good Luck
        Experience is something you don't get until just after you need it.

        Comment


        • #5
          aww thanks mayo. i am just messing with pc lol

          Comment


          • #6
            hey mayo i finely got blade to hold i back sawing ,,well when i finish my night shift,,,,,

            Comment

            Unconfigured Ad Widget

            Collapse

            Latest Topics

            Collapse

            • Bill Wilson
              Reply to Tough Decisions
              by Bill Wilson
              Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
              Today, 09:51 AM
            • planeur
              Reply to My covid angel
              by planeur
              Thanks to all !😀 Your comment are very good and make sense!

              My piece is 8"X8" X 1/2" thick.
              I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
              Was it a good idea.....?...
              Today, 09:45 AM
            • Rolf
              Reply to My covid angel
              by Rolf
              Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
              Today, 09:02 AM
            • Rolf
              Reply to Tough Decisions
              by Rolf
              The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
              Today, 08:49 AM
            • NC Scroller
              Reply to My covid angel
              by NC Scroller
              I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
              Today, 07:27 AM
            Working...
            X