Announcement

Collapse
No announcement yet.

Adjust Hawk 220vs table to center saw blade

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adjust Hawk 220vs table to center saw blade

    When I picked up my used 220VS, I noticed the hole in the aluminum table had been cut by the saw blade. I found the saw blade is not centered on the hole. I do not have a user manual yet but I doubt it tells how to center the blade on the hole. Does anyone know how to adjust the table so the hole is centered on the blade?

  • #2
    welcome to the forum but you should do a little searching as there are several posts on this subject on here. most saws have the same fix i think


    + + I Love The Smell Of Sawdust In The Morning + +

    Comment


    • #3
      Usually the reason for a cut table is loose tension and someone pushing sidways on the blade. How about a picture so we can see how bad it is.
      Rolf
      RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
      Philosophy "I don't know that I can't, therefore I can"
      Proud Member of the Long Island Woodworkers Club
      And the Long Island Scrollsaw Association

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • NC Scroller
        Reply to Frustrated
        by NC Scroller
        I am guessing that your clamps have probably spread due to usage. I am not aware of any aftermarket clamps that fit your saw. Did you look at ereplacementparts.com to see if they sell clamps for your model? Sorry I could not be of more help.
        Today, 11:24 AM
      • Daddy's scroller
        Reply to Frustrated
        by Daddy's scroller
        I have a craftsman saw. The blade just slips out.
        Yesterday, 07:00 PM
      • Daddy's scroller
        Reply to Frustrated
        by Daddy's scroller
        No. I haven't tried that yet...
        Yesterday, 06:55 PM
      • Chance13
        Reply to Frustrated
        by Chance13
        I put those on my 20" Dewalt a couple years ago. Big improvement from the one Dewalt had....
        Yesterday, 11:08 AM
      • Rolf
        Reply to Frustrated
        by Rolf
        We need to know what saw you are using, as they have different clamps.
        Yesterday, 07:59 AM
      Working...
      X