Announcement

Collapse
No announcement yet.

Adjust Hawk 220vs table to center saw blade

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rolf
    replied
    Usually the reason for a cut table is loose tension and someone pushing sidways on the blade. How about a picture so we can see how bad it is.

    Leave a comment:


  • Northerner
    replied
    welcome to the forum but you should do a little searching as there are several posts on this subject on here. most saws have the same fix i think

    Leave a comment:


  • n7yge
    started a topic Adjust Hawk 220vs table to center saw blade

    Adjust Hawk 220vs table to center saw blade

    When I picked up my used 220VS, I noticed the hole in the aluminum table had been cut by the saw blade. I found the saw blade is not centered on the hole. I do not have a user manual yet but I doubt it tells how to center the blade on the hole. Does anyone know how to adjust the table so the hole is centered on the blade?

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • NC Scroller
    Reply to Frustrated
    by NC Scroller
    I am guessing that your clamps have probably spread due to usage. I am not aware of any aftermarket clamps that fit your saw. Did you look at ereplacementparts.com to see if they sell clamps for your model? Sorry I could not be of more help.
    Today, 11:24 AM
  • Daddy's scroller
    Reply to Frustrated
    by Daddy's scroller
    I have a craftsman saw. The blade just slips out.
    Yesterday, 07:00 PM
  • Daddy's scroller
    Reply to Frustrated
    by Daddy's scroller
    No. I haven't tried that yet...
    Yesterday, 06:55 PM
  • Chance13
    Reply to Frustrated
    by Chance13
    I put those on my 20" Dewalt a couple years ago. Big improvement from the one Dewalt had....
    Yesterday, 11:08 AM
  • Rolf
    Reply to Frustrated
    by Rolf
    We need to know what saw you are using, as they have different clamps.
    Yesterday, 07:59 AM
Working...
X