Adjust Hawk 220vs table to center saw blade

n7yge

Junior Member

Join Date: Feb 2012

Posts: 2
- Share
- Tweet
#1

Adjust Hawk 220vs table to center saw blade

02-19-2012, 04:59 PM

When I picked up my used 220VS, I noticed the hole in the aluminum table had been cut by the saw blade. I found the saw blade is not centered on the hole. I do not have a user manual yet but I doubt it tells how to center the blade on the hole. Does anyone know how to adjust the table so the hole is centered on the blade?
Tags: None
Northerner

Member - Level 2

Registered User - Level 2

Join Date: Nov 2009

Posts: 239
- Share
- Tweet
#2

02-19-2012, 05:43 PM

welcome to the forum but you should do a little searching as there are several posts on this subject on here. most saws have the same fix i think

+ + I Love The Smell Of Sawdust In The Morning + +
Comment
Rolf

The WoodMeister

Join Date: Apr 2005

Posts: 12200
- Share
- Tweet
#3

02-20-2012, 08:31 AM

Usually the reason for a cut table is loose tension and someone pushing sidways on the blade. How about a picture so we can see how bad it is.

Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw Association
Comment

Previous template Next

Reply to Tough Decisions

by will8989

I did that with Creative Woodworks. But when Bruce's group had their monthly meetings and swaps, somehow or other the ones I didn't buy ended up here! I keep all my holiday ones separate. But I also look at other patterns and think how I can reuse it. But sometimes that is just too much for my brain...
- Channel: Publisher Feedback
Today, 12:27 PM
Reply to Tough Decisions

by Don in Brooklin On

Since I refuse to subscribe till they do something about the patterns in the pull out. They even made the DVD tough to print patterns.

What I do is look at the index of the book on scrollsawer.com and if see something I might want to cut I go to Walmart and check out the book. If I like...
- Channel: Publisher Feedback
Today, 11:59 AM
Reply to Tough Decisions

by Linda In Phoenix

Absolutely everyone here has made valid points. That's part of what I've liked about this group.....different view points and different ideas. And we respect the diversity. You people rock!
- Channel: Publisher Feedback
Today, 11:24 AM
Reply to Tough Decisions

by NC Scroller

I too miss Bob Duncan. I do not think anyone from FC has taken over that role at least on this forum. If they have I am not sure who. Like Betty, I owe a lot to FC and this forum. If it was not for them and this forum I would have probably turned my saw into a boat anchor years ago. Oh how I looked...
- Channel: Publisher Feedback
Today, 11:22 AM
Reply to My covid angel

by NC Scroller

Yes I would sand all around the hand and feet to give it some depth.
- Channel: New Scroll Saw Patterns or Designs
Today, 11:03 AM

Announcement

Adjust Hawk 220vs table to center saw blade

Comment

Comment

Unconfigured Ad Widget

Latest Topics