Announcement

Collapse
No announcement yet.

Pinned to Pinless

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Pinned to Pinless

    Here is a question that I need help with. I have a Wilton scroll saw that uses 5 inch pinned blades. Is there an device that I can change out that would allow me to use pinless blades? I know the head comes off so that is the part I think I need to change.

    Any advice would be greatly appreciated.
    Tags: None
  • #2
    Pin to pinless

    There is a source out there, Pozsgai's Designs.
    They have several adapter for different scroll saws.
    If you contact them I am sure they can help.
    CAЯL HIRD-RUTTEЯ
    "proud member of the best scroll sawing forum on the net."
    Ryobi SC180VS scroll saw EX21

    Comment

    Previous template Next

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse
    • will8989
      Reply to Farmers market "survey"
      by will8989
      This market is run a little different than most. All monies collected go back into the market. Each month they put on a different event to draw in people. The budget is usually $600 in the busy months. The pavilion is well maintained with sides that pull down in the colder months. The only time Sunday...
      Today, 01:41 AM
    • cwmagee
      Pegas Large Scrollsaw Table
      by cwmagee
      A couple of months ago I ordered the Large Pegas Scroll Saw Table for my EX21 from Denny which I received about a week later. I installed it immediately and made a few test cuts. Since then I have been busy with several Urban renewal projects around house as well putting the yard to bed for the winter....
      Yesterday, 07:28 PM
    • Rolf
      Reply to I admit it... I splurged on a new "toy"
      by Rolf
      Back in the late 90's I bought a Incra 2000 Miter gauge. Incredibly precise. The problem was that it only adjusted in one direction, It rarely gets used. It locks in to half degrees. More recently I bought a Kreg fence which has a pin that precisely locates the frequently used angles.
      That is...
      Yesterday, 08:15 AM
    • Jimern
      Reply to Farmers market "survey"
      by Jimern
      The crafters market here in Kerrville, TX is $25 per 10x10 spot per event. We sell 8 months out of the year, Jun/Jul is too hot, and Jan/Feb is too cold. No insurance requirement but we do have to show a sales tax permit and collect sales tax.

      Personally I would never sell in a venue that...
      Yesterday, 06:29 AM
    • will8989
      Reply to Farmers market "survey"
      by will8989
      The one I do is under a pavilion on County Property, about 60 spaces. They run 4 “seasons”, spring 6 weeks, summer May - mid September, fall sept to Mid November, and holiday fare Mid November until end of year. Cost is $75 per season, per day as they are open Saturday and Sunday. If you are called...
      10-20-2020, 11:10 PM
    View All
    Working...
    X