Announcement

Collapse
No announcement yet.

What is veining?

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • What is veining?

    I have been scrolling for about 13 years and still don't know what is meant by veining. I must do it and maybe call it something different. They say that what you learn after you know it all is what counts. Mick.
    Mick, - Delta P-20

    A smile is a small curve that straightens everything out.

  • #2
    Veining is the thin, cuts inside a scrolled work that don't cut anything off, just add detail...like hair in a portrait, or the detail lines of the Walt Disney Castle in Issue 18..Or the details of the tank in Issue 17 on page 77.


    Bob

    Comment


    • #3
      BobD, now I guess I know it all. Mick.
      Mick, - Delta P-20

      A smile is a small curve that straightens everything out.

      Comment


      • #4
        Its not a tank tho bob according to issue 18 LOL
        I am a nobody and no body is perfect...........therefore I am perfect

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • will8989
          Rolf,
          by will8989
          Are you ok Rolf?
          Today, 05:43 PM
        • Jim McDonald
          Reply to About ornament exchange
          by Jim McDonald
          Dave, I will participate. Thanks for doing this again.
          Today, 09:10 AM
        • Rolf
          Reply to Testing this blower motor
          by Rolf
          Without the complete schematic it is hard to know what is correct.
          That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
          Today, 07:43 AM
        • evilbadger
          Reply to Testing this blower motor
          by evilbadger
          If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
          Today, 06:40 AM
        • cwmagee
          Reply to Testing this blower motor
          by cwmagee
          The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

          You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
          Yesterday, 08:41 PM
        Working...
        X
        😀
        🥰
        🤢
        😎
        😡
        👍
        👎