If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
That turned out excellent. Is the overall 18 inches or just the center section? The contrasting wood and blue background makes it pop. Awesome job cutting too.
Tim
If you need a tool and don't buy it, you will pay for it and not have it
Wow. That is some great cutting. Nice straight lines, great curves and consistent spacing between all those close lines. Thanks for the updates as you went along.
Here is somes of my inserts , in ebony , and I put to reinforce at the back of the bird (chickadee ) a MDF with real wood on each side , total of .096" , because the cuttings was very delicates ! Still have some sanding on a couple of them!
An Alex Fox Pattern C-03. I enlarged the pattern by 30% to fit 1/4" Baltic Birch plywood 10" square. Cut on the Pegas Scroll Saw using Pegas #1 MGT blades. Entry holes drilled with Grobet #68 HSS Twist Drill Bits. Finish is two coats spray Lacquer Clear Gloss with sanding on the Mac Mop between...
Tweet
Karl in Sunny Southwest Florida 
Comment