Announcement

Collapse
No announcement yet.

brother potrait,

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GladeFade
    replied
    Here is my attempt. Feel free to change as needed.
    portrait4.jpg

    Leave a comment:


  • GladeFade
    replied
    Much better picture, I will give it a try. Be patient.

    Leave a comment:


  • NC Scroller
    replied
    Sorry I wish I could help but I am not a designer. I do remember your first request and yes that was a rather small image. Wishing you all the best.

    Leave a comment:


  • jamescroller
    started a topic brother potrait,

    brother potrait,

    recently my older brother passed away,ive been wanting to make a scrollsaw potrait of him,i recently posted pictures but hadnt much feed back,i suspect it was due too the wuality of the picture,so im here again hoping this time the picture is better,fingers crossed,i do hope someone out there can convert...thanks in advance
    Attached Files

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • markdavd
    Reply to Frustrated
    by markdavd
    When a blade slips out, the tendency is to tighten it more. Make sure you haven't over-tightened the clamp forcing the sides apart. Most OEM clamps are made from soft aluminum so once it starts they will continue spreading and it will be near-impossible to keep the blades in place.

    I've...
    Today, 10:03 AM
  • Sandy Oaks
    Reply to Frustrated
    by Sandy Oaks
    Blade slippage is a function of the blade clamp holder and or the set screw and thumb screw with swivel.
    Today, 09:40 AM
  • NC Scroller
    Reply to Frustrated
    by NC Scroller
    Tricia what saw do you have? Does the blade slip or it just won’t tighten?
    Today, 08:01 AM
  • wjbclocks1
    Reply to Frustrated
    by wjbclocks1
    Are yoou sure that your not puting the blades to far up in the top clamps,. ( l learned thst the hard way)...
    Today, 07:46 AM
  • cwmagee
    Reply to Frustrated
    by cwmagee
    Have you tried to rough up the thumb screws tips? How old are the blade clamps? may be time to replaced them.
    Today, 06:48 AM
Working...
X