If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Depends, are you planning on using some sort of backer ? If so you could cut the leaves and leave the rest, or if you are trying to make it all one piece maybe try to trace it and while you are doing that give the leaves little connecting points.
Do LED Strip Lights Consume a Significant Amount of Electricity?
Modern advancements in technology have opened up a plethora of energy options for people around the world. With a wide range of electrical devices available, individuals are faced with the task of choosing...
Our Judges are some of the best woodworkers I have ever met. On occasion I get asked to explain what I look for in the scrolling categories. I point out all of the nuances. I can't be a judge as I have intarsia and scroll work entries.
There may have been some crud on the tips from manufacturing.
In the ~20 years of scrolling I never cleaned the ends of my blades until recently. Even with the Pegas clamps I was having some blade slippage, I now scuff the ends of my blades with some 220 grit paper End of problem.!...
Don’t over sand them as you will shorten their usable life. Only sand as needed. Another thing to do is clear your blades before installing. Blades are coated with oil to prevent rust. Wipe the ends with alcohol or lightly sand with 320 grit.
Tweet
Comment