Announcement

Collapse
No announcement yet.

My Favorite Uncle Pls Help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • My Favorite Uncle Pls Help

    After a short break I am back in the shop and the dust is flying.

    I now need your help for my next project. I will include two photos of my Uncle Buddy. He is my favorite Uncle and he passed away shortly after my Grandfather did. I would like to do this for his wife if anyone can please help I will be grateful.

    Thank you
    Levi

  • #2
    Here is my take on your Uncle Buddy. Hope you can use it.
    Don R
    http://www.oldcrowwoodcrafts.weebly.com
    http://www.oldcrowscrollwerks.weebly.com
    Custom Made Scroll Saw Patterns

    Comment


    • #3
      Here's your uncle....hope it will work for you....Ron
      Ron

      Comment


      • #4
        Levi...Here's the younger version...Ron
        Ron

        Comment


        • #5
          Thank both of you. I will post when I am finished.

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • handibunny
            Reply to EX dust collection holes screwed up a project.!
            by handibunny
            Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
            Today, 09:21 AM
          • Bill Wilson
            Reply to EX dust collection holes screwed up a project.!
            by Bill Wilson
            I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
            Today, 09:06 AM
          • cwmagee
            Reply to EX dust collection holes screwed up a project.!
            by cwmagee
            Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
            Today, 08:40 AM
          • Rolf
            Reply to EX dust collection holes screwed up a project.!
            by Rolf
            That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
            Today, 07:28 AM
          • handibunny
            Reply to EX dust collection holes screwed up a project.!
            by handibunny
            Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
            Today, 06:21 AM
          Working...
          X