If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone care to take on this portrait? Its for a close friend of mine. Need it designed by the weekend otherwise I have to think of something else. Thanks to anyone who can help.
Back in the late 90's I bought a Incra 2000 Miter gauge. Incredibly precise. The problem was that it only adjusted in one direction, It rarely gets used. It locks in to half degrees. More recently I bought a Kreg fence which has a pin that precisely locates the frequently used angles.
That is...
The crafters market here in Kerrville, TX is $25 per 10x10 spot per event. We sell 8 months out of the year, Jun/Jul is too hot, and Jan/Feb is too cold. No insurance requirement but we do have to show a sales tax permit and collect sales tax.
The one I do is under a pavilion on County Property, about 60 spaces. They run 4 “seasons”, spring 6 weeks, summer May - mid September, fall sept to Mid November, and holiday fare Mid November until end of year. Cost is $75 per season, per day as they are open Saturday and Sunday. If you are called...
Ours are run by the state Ag Dept. They have very strict rules as to masks and distancing. The Ag Dept does come and visit to make sure rules are being followed. We stand behind the table and use the tailgate for packaging. I have people place their credit card in the reader on my phone and remove...
Linda - Here is my gimmick for the Incra 1000SE on my SS CNS. I scratched a line 3/4-inch in from the blade end of the fence. I then use a ruler to set that line 1-inch from the side of a carbide tooth on the blade. Then I line the 1-inch mark on the fence ruler to the scratch line.
Tweet
Comment