Announcement

Collapse
No announcement yet.

Gimp or Inkscape

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gimp or Inkscape

    Are there any folks out there that are useing either Gimp or Inkscape for portraits..If so who...I want to know who thinks which one is better...Thanks a heep....Cj1

    I moved your thread to a more appropriate forum to maximize traffic and get you more responses to your request/question.
    Last edited by wood-n-things; 02-06-2012, 01:04 PM.

  • #2
    I use them both in tandem.
    Don R
    http://www.oldcrowwoodcrafts.weebly.com
    http://www.oldcrowscrollwerks.weebly.com
    Custom Made Scroll Saw Patterns

    Comment


    • #3
      I have used Gimp and it takes a bit to get used to. I have Inkscape loaded but have not used for portraits.

      There is a good tutorial using Gimp for portraits at Scrollsaw Village.

      Scroll Saw Portraits using GIMP - L1 • Scroll Saw Village

      Don
      Don McFarland ​Member - Durham Woodworking Club http://www.durhamwoodworkingclub.com/

      Comment


      • #4
        I use both.
        Scott
        Creator of fine designer sawdust.

        Comment


        • #5
          While I have Gimp loaded, I don't really use it, I use Photoshop7, even thogh they work very much the same. As far as Inkscape, I use it to clean up my patterns and to finalize the size of them. So Gimp/Photoshop is my main work horse for making my patterns and Inkscape is my cleanup program.
          CHRIS


          http://www.members.cox.net/messman123/messman.htm

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • dwssr2
            Reply to hegner 2"
            by dwssr2
            I have no idea what the measurements of the 18" table are, I can give measurements of the poly max and the 14"....
            Today, 05:22 AM
          • MidMich324
            Reply to hegner 2"
            by MidMich324
            Just Wondering...

            Is the table size on the 22" hegner saw as on the 18" hegner saw?

            With the 22" inch one you get 4 more inches of depth of cut but do you also get a few more inches of table?
            Yesterday, 09:30 PM
          • will8989
            Reply to Spring Issue
            by will8989
            I had to fool around with copying and taping a pattern again today. This wasn’t as bad as the fish, but still a pain. I use rapid resizer. Scan a pattern, put in size I want and it prints it out. If more than one page, it numbers each page at the top and I tape them together. Had the fish pattern...
            Yesterday, 09:28 PM
          • millwab
            Reply to Peanuts #1
            by millwab
            Rolf, I cover it with clear contact paper (comes off clean without leaving a residue) and draw a grid for the direction I want to cut (ie horizontal or diagonal) to keep the rows even. The rest is all freehand....
            Yesterday, 02:51 PM
          • Don in Brooklin On
            Reply to Spring Issue
            by Don in Brooklin On
            Rolf

            I use acrobat reader. The poster feature will enlarge and if it goes to multiple pages it will put in cut marks. Even if the page is over letter size it will spread to multiple pages at 100%.

            If it is in PDF form you can open with Inkscape or GIMP and select what you...
            Yesterday, 01:48 PM
          Working...
          X