No announcement yet.

Pic to Pattern request Please and Thank You

  • Filter
  • Time
  • Show
Clear All
new posts

  • Pic to Pattern request Please and Thank You

    I tried myself to make this into a pattern but cant seem to get anything workable. the picture is of a little girl while she was in the hospital and I need the pattern minus the feeding tube. this is a request for a memorial pattern.
    Any and all help would be greatly appreciated.

    Please email any pattern to [email protected] thanks.

    Jim Yuktuk Murley


  • #2
    Wow a bigger picture would sure help, tough when the pictures are this small.


    • #3
      I don't know if this will help, it was a small picture. I sent a copy to your email addy also.
      Attached Files


      Unconfigured Ad Widget


      Latest Topics


      • markdavd
        Reply to Frustrated
        by markdavd
        When a blade slips out, the tendency is to tighten it more. Make sure you haven't over-tightened the clamp forcing the sides apart. Most OEM clamps are made from soft aluminum so once it starts they will continue spreading and it will be near-impossible to keep the blades in place.

        Yesterday, 10:03 AM
      • Sandy Oaks
        Reply to Frustrated
        by Sandy Oaks
        Blade slippage is a function of the blade clamp holder and or the set screw and thumb screw with swivel.
        Yesterday, 09:40 AM
      • NC Scroller
        Reply to Frustrated
        by NC Scroller
        Tricia what saw do you have? Does the blade slip or it just won’t tighten?
        Yesterday, 08:01 AM
      • wjbclocks1
        Reply to Frustrated
        by wjbclocks1
        Are yoou sure that your not puting the blades to far up in the top clamps,. ( l learned thst the hard way)...
        Yesterday, 07:46 AM
      • cwmagee
        Reply to Frustrated
        by cwmagee
        Have you tried to rough up the thumb screws tips? How old are the blade clamps? may be time to replaced them.
        Yesterday, 06:48 AM