If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
There is one in the Big Book of Christmas Ornaments and Decorations (The Best of SSW&C) by Julie and Fred Byrne. The pattern was called Christmas Tree Display. It should be in one of the issues of the magazine but I'm not sure which one
"It is so cute" - it is the first what I hear when I show this project. I haven’t done 3D patterns for a long time (about a year), it’s quite difficult and takes a long time. But I don’t regret the time I spent on this new pattern - Christmas deer, I think it turned out great. It is...
Making of 3D scroll saw project - Christmas deer. Pattern is available at PDF and vector formats, so you can use it for srollsawing, lasercutting or CNC. Pat...
I've been using the bags from Amazon and a heat gun my wife bought when she was a preschool teacher. Unless you are wrapping of small parts, you don't need a sealer. Just fold it over and hold it with a small piece of scotch tape on the back. After you shrink it it's sealed enough to keep everything...
My process is a bit different. Since I am using heat shrink bags when you seal the open end you trap a lot of air in them. When you start to heat the bag to shrink it you create a large bubble. I continue to heat the bag until it does pop a hole. I have been doing this for years. The shrink wrap...
Tweet
Comment