help for a portrait - Scroll Saw Woodworking and Crafts Message Board

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

TOUITOUI

Member - Level 2

Join Date: Nov 2008

Posts: 131
- Share
- Tweet
#1

help for a portrait

09-01-2011, 04:55 AM

can anyone help me to convert this photo please.
thank you in advance
Attached Files

DSC_3107_0006 2.jpg (53.9 KB, 22 views)

Last edited by TOUITOUI; 09-01-2011, 11:29 PM.
Tags: None
joleet

Member - Level 2

Registered User - Level 2

Join Date: Nov 2008

Posts: 359
- Share
- Tweet
#2

09-02-2011, 01:49 PM

Will this help?....Ron
Attached Files

touitoui.jpg (138.9 KB, 18 views)

Ron
Comment
sappy

Senior Member

Registered User - Level 2

Join Date: Nov 2008

Posts: 937
- Share
- Tweet
#3

09-03-2011, 11:41 AM

Nice pattern, Ron!
Comment
TOUITOUI

Member - Level 2

Join Date: Nov 2008

Posts: 131
- Share
- Tweet
#4

09-03-2011, 02:33 PM

thank you

thank you very much. very very nice job.
Touitoui
Comment
Oges

Member - Level 2

Join Date: Aug 2010

Posts: 241
- Share
- Tweet
#5

09-04-2011, 06:47 PM

Nice work Ron

Brett

Only Robinson Crusoe could get everything done by Friday!
Comment

Previous template Next

Reply to My beauties

by will8989

He puts biscuts between the long pieces, is that what you meant? He has stainless screws in the lips then puts the plugs on top of that. Scott, cutting one doesn’t take long. It’s the removing of the tiny drill hole, spraying each piece with distilled water, letting dry, sanding and sometimes flap...
- Channel: Works in Process
Today, 10:55 AM
Reply to Cutting guide for straight cut on a scroolsaw

by Rolf

Like Bob said clamp a straight edge to the table and adjust it to compensate for the blade drift. There are some blades that have no or very little drift. Like the Olson PGT series it also seems to me that the Pegas MGT 3 or larger cut very straight....
- Channel: Tools and Blades
Today, 07:54 AM
Reply to My beauties

by Rolf

I now you do beautiful work but I have to say your attention to details on these baskets is impressive. soft smooth edges, no visible glue squeeze out. And of course the cutting boards are beautiful. I am guessing that Bruce cut a spline in the end of the board and then dowels. I have not seen that...
- Channel: Works in Process
Today, 07:49 AM
Reply to My beauties

by NC Scroller

You are one busy lady. About how long does it take to cut one?
- Channel: Works in Process
Today, 05:51 AM
Reply to Hegner Multimax-18 for sale Tucson

by NC Scroller

Good luck.
- Channel: General Scroll Saw
Today, 05:47 AM

Working...

X