If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No announcement yet.
Locomotives - seeking fretwork patterns of steam locos
I used a Pegas 2/0 skip tooth blade for this and all my 1/4" plywood puzzles. Any 2/0 blade will give similar results, as long as it is a simple blade which cuts only on the down-stroke. I stick with Pegas because I have found them to be consistent....
Rolf, I use White pine or Cedar but the most important aspect is the painting technique. I always put on a white primer, use fine steel wool to remove imperfections, Apply exterior outdoor paint, rub fine steel wool after each application when dry and final finish I apply clear poly ( spray can )...