Announcement

Collapse
No announcement yet.

Alarm Pul Box Wall Plate plans

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Alarm Pul Box Wall Plate plans

    A few of you showed interest in the plans from my Fire Alarm pull Box switch plate so I looked around and found them. I just added the sheet with the decals on it this past hour. As always, I suggest you cut everything out and dry fit it before taking for granted everything is correct after printing it out on your printer. Enjoy! Any criticism is welcomed.
    Pop
    Attached Files
    Pop
    Delta 16" 40-530
    Ryobi 16" VS

    "Never be afraid to try something new. Remember it was amateurs that built the ARK but Professionals that built the Titanic!"

  • #2
    That's awesome, but way too realistic. If I put that where my great grand kids could get to it, they would be pulling every fire alarm in town, just to turn on lights.
    Tony

    My Son-in-law said "Darnit, I cut this board twice, now. And it's still too short."

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • will8989
      Advent wreath
      by will8989
      For one of my good customers. From the fall issue 2016. Cherry and African mahogany. Bruce turned the candle holders as we couldn’t find candles to fit any already made wooden holders. I used the green sparkle unicorn spit over green paint for holly leaves and red for the berries. Yes, I actually...
      Yesterday, 11:39 PM
    • Ennobee
      Reply to 10" long truck.
      by Ennobee
      Looks pretty neat. So it's from a 2x4: 3 in wide, 'bit less then 2 in. high? So how did you get the trunk cut out? You mentioned cutting the sides with a scroll saw, did you slice off two sides and then cut out the middle?...
      Yesterday, 09:46 PM
    • vgraf
      Reply to sanding sealer or shellac
      by vgraf
      I use sanding sealer on baltic birch plywood, pine and birch if I am going to stain them. Without the sanding sealer, the stain will be blotchy. I use the water base sealer from minwax. After it drys I sand to at least 150 grit and often to 220 grit. Wipe it with a tac cloth then apply the masking...
      Yesterday, 08:27 PM
    • Jim Finn
      Reply to 10" long truck.
      by Jim Finn
      We, our club, delivered over 900 toys last week to The Salvation Army, Ronald McDonald House, and a local children's hospital. Included were most of these trucks. (I sold a few)
      Yesterday, 07:17 PM
    • NC Scroller
      Reply to sanding sealer or shellac
      by NC Scroller
      The real nice thing about using shellac and alcohol mix for ornaments is you only have to wait minutes before you tie in your ribbons and packaging.
      Yesterday, 10:48 AM
    Working...
    X