Announcement

Collapse
No announcement yet.

Just Starting scrolling

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • wood-n-things
    replied
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

    Whatever reason brought you to our forum we are pleased you found us.

    Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.

    Leave a comment:


  • 3_M
    replied
    RJweb, make sure when you get a saw that it will take pin-less blades.
    After you get the saw make sure you have good tension on the blade. The blade should not move sideways more than 1/4". Have good speed, if not you might push too hard into the blade and the blade might start cutting with a bevel. Have slow feed rate.
    You can always email me if you have more questions.
    FD Mike

    Leave a comment:


  • bstark
    replied
    Welcome! I think you will like it. I am new too and I was not so sure and a bit nervous about the initial investment... but the amount of 'entertainment' time with the hours I have already spent has been well worth it.

    -brad

    Leave a comment:


  • jsweig2579
    replied
    Welcome to the forum RJ. Lot of good information located here and lots of gurus to answer any questions you may have.

    JerryS

    Leave a comment:


  • RJweb
    started a topic Just Starting scrolling

    Just Starting scrolling

    Good afternoonn,
    I am just now starting to get into scrolling, in fact I don't have a scroll saw yet. Been doing woodwork for a few years and thought I would try this for a while.

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

Working...
X