Just getting back into scrolling after several years away. I am currently in the process of refurbishing my Delta 16 in scroll saw with plans to try my hand at scrolled bowls. Prior to my extended hiatus I had been involved in scrolling for about 5 years, and general woodworking for more than 30 years. I look forward to getting to know the folks here in this community, sharing ideas and experiences.
Announcement
Collapse
No announcement yet.
Glad to be here...
Collapse
X
-
Welcome back I am sure you will be up to speed in no time... there are plenty of patterns and tips here at this forum if you need a refresher so feel free to jump in and use the forum as you need.
Just remember we need pictures or else it is just words..... no pictures it didn't happen.
-
I promise, I will post plenty of pics as I get things going. Just spent the morning at the hardware store hunting assorted screws and scrounging items to finish getting this saw back into operation and build some incarnation of dust collection.
With the screws I found I should have the saw at least working, though I fear the work surface is going to require a trip to the local machinist. I had stored it in my dads barn and what at first looked like surface rust actually has pitted it a good dealAh well, what fun would it be without a little challenge from time to time?
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to Picked up a new toy yesterday!by jim_mexHi Rolf - I bought the Marietta through Amazon Mexico. I never thought to check if it showed on the US site. I use both of these sites quite a lot but where possible buy through the Mexico site even if items are listed as being imported because import duties and delivery charges where applicable are...
-
Channel: Off Topic
Yesterday, 06:22 PM -
-
Reply to Sanding and calibration disk.Thank you for sharing. I'd seen that item but didn't get it. Now I'm glad. Will wait and see how they respond to you....
-
Channel: Tools and Blades
Yesterday, 05:42 PM -
-
Reply to First Project - Stretching CatThat turned out very nicely. And that paint really set it off!...
-
Channel: General Scroll Saw
Yesterday, 05:40 PM -
-
Reply to First Project - Stretching Catby NC ScrollerNice job. Scroll sawing can be addictive.
-
Channel: General Scroll Saw
Yesterday, 04:41 PM -
-
This my first project from the Scroll Saw Workbook. I used a veiner gouge and some acrylic paint to finish it....-
Channel: General Scroll Saw
Yesterday, 04:27 PM -
Comment