If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am happy i found this website and became a member. It will be nice to have someone to ask questions and get advice from. Hope everyone has a great day
Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.
You may find the stickies at the top of this forum to be very helpful. Use the Link below.
Keep in mind this is a two way street. You can ask questions but if you have the answer to someone elses question we want your imput also.... once said by a wise man:
"A problem looked at from two different angles can have more than one solution!"
You did a beautiful job with it. Great paintwork! I can see Carving the prop out of one piece considering the grain direction changes etc. was a challenge.
By the way, I did not follow the dimensions exactly as I just used scrap wood that was lying around and scaled to fit - also, for the propeller, I decided to make it from a single block - that turned out to be slightly more difficult than first imagined... but it works!
Comment