Announcement

Collapse
No announcement yet.

Hey from North Alabama

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hey from North Alabama

    Just coming on to this site. Have been doing scrolling for about 6 years. Decided I liked it better than working, so I retired. Have been doing craft shows in area. Just finished one where I did fairly well, especially considering many of my things are under $20.

  • #2
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

    Whatever reason brought you to our forum we are pleased you found us.

    Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment


    • #3
      Welcome aboard! I am Tony,aka,Toneman from Paris, Texas and have only been scrolling for 4 months. I have gained so much knowledge from this forum family, and am looking forward to see some of your work.

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • tgiro01
        Old Tool - Reborn
        by tgiro01
        With all these new tool stories, I was working on and old one. About 9 years ago, I built a router table. Then, before it was finished, I had to start using it. And I have used it over the years. A couple of months ago, While I was contemplating cleaning, I looked at the machine and decided to finish...
        Today, 03:24 PM
      • Rolf
        Reply to YoraHome Laser w/CNC Engraver/Router
        by Rolf
        I do remember that 2011 Wow, you were gutsy building that then, CNC was just coming into the home environment. Are you still using the one you built?
        Today, 10:23 AM
      • Rolf
        Reply to Work in Progress. What is with FOX publishing?
        by Rolf
        Jim that is why there are now CD's available for past issues. To me a copier/scanner and printer are a necessary part of my tool inventory. JMO...
        Today, 10:19 AM
      • Jimern
        Reply to Work in Progress. What is with FOX publishing?
        by Jimern
        I dropped my subscription long ago, so maybe I should not chime in, but I dropped it mostly due to the pattern pull out.

        I do not have a flat bed scanner, nor do I want one, so that is my issue.

        But the result is that if I cut a pattern to scan, I have also cut the parts of...
        Today, 07:55 AM
      • Quartz43
        Reply to Work in Progress. What is with FOX publishing?
        by Quartz43
        +1 on NC Scroller's suggestions. I would add that on appropriate patterns stop using the grey as it would make it easier to copy.

        It says a lot if Fox Publishing does not comment on an issue like this. Even if they said they are aware that people have concerns and are looking into it...
        Yesterday, 08:15 PM
      Working...
      X