Newby

[brasscutter]

Hello scroll sawyers. I plan to cut intricate patterns in sheet brass using a newly acquired Delta Q3. It's dead and won't even growl.

I spent most of the day removing the electronic velocity control box and while I was at the task, learned much about the mechanics of the machine. I can appreciate why the machine is quiet and smooth running.

As said, the EVC has an issue; I'm troubled that there doesn't readily seem to be a source for a replacement EVC circuit board. The motor is OK so I may have to resort to an after-market EVC.

[wood-n-things]

I can't help you with the part. Have you tried ereplacement.com?

Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

You may find the stickies at the top of this forum to be very helpful. Use the Link below.

Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

Take a few minutes to read through them. They are chock full of great information.

Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

Whatever reason brought you to our forum we are pleased you found us.

Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.

[Daddy's scroller]

welcome aboard