No announcement yet.


  • Filter
  • Time
  • Show
Clear All
new posts

  • Newbie

    Hi to all ! Just signed up. Hope to learn a lot.

  • #2
    Hi there, welcome to the club, I'm sure you will learn alot here, I too am a newbie and have learnt an incredible amount from this forum, so dive in, everyone seem's friendly and willing to help.
    this space for rent


    • #3
      Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

      You may find the stickies at the top of this forum to be very helpful. Use the Link below.

      Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

      Take a few minutes to read through them. They are chock full of great information.

      Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

      Whatever reason brought you to our forum we are pleased you found us.

      Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.
      "Still Montana Mike"

      "Don't worry about old age--it doesn't last that long."
      Mike's Wood-n-Things LLC


      • #4
        Hi, welcome to the group.

        Delta P-20 & Q-3

        I wondered why the baseball was getting bigger. Then it hit me!


        • #5
          Welcome Sandyjo! You will enjoy this forum. I am a new scroller and have gotten some fantastic help from here.

          Tony (aka Toneman) from Texas


          Unconfigured Ad Widget


          Latest Topics


          • Jo Labre
            Reply to Joining the new tool frenzy
            by Jo Labre
            I cut a bunch of chakte viga and leopardwood pieces for the Viking project and the blade seems pretty good yet. I imagine if I were to only cut softer hardwoods (?) the blade would last quite a long time. Still - $25.00 is a lot more than the cost of standard scroll saw blades....
            Today, 02:36 PM
          • old fa_t
            Reply to Old,,,,but new here
            by old fa_t
            The room was supposed to be storage but it's my office? now with a roll top desk and a barristers bookcase.which I built when I was able.
            Today, 01:55 PM
          • Rolf
            Reply to Joining the new tool frenzy
            by Rolf
            Very nice! I really like your setup especially for the dust collection. I would have to figure out a way to re-weld the blade.
            And Oh to have wall space and organizational skills!
            Today, 09:55 AM
          • Rolf
            Reply to Old,,,,but new here
            by Rolf
            Welcome! As the others have said, lots of support and knowledge here ready to be shared.
            Is the 6 x10 your workspace or your entire apartment. ?
            Today, 09:34 AM
          • Rolf
            Reply to Log slice ornaments
            by Rolf
            Most of the cut outs were done with the scroll saw.
            Karl I have a couple of power carvers. The classic Dremel with a flex shaft I then bought a Ram Power carver, they both use 1/8 shank bits. I have a bunch of carbide cutters from when our Printed circuit board facility at work was dismantled....
            Today, 09:29 AM