Announcement

Collapse
No announcement yet.

Mr K

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mr K

    Thanks to all of you for sharing your craft w/me. I am new to your forum and hope that I can be a bonnified contributor. After looking thru the Gallery I can see very creative minds at work. !

  • #2
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

    Whatever reason brought you to our forum we are pleased you found us.

    Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • will8989
      What is it?
      by will8989
      Bruce was bored and made this. What is it?...
      Today, 10:57 PM
    • will8989
      Reply to First you need to make a mess
      by will8989
      It was a challenge that’s for sure. I didn’t start anything until I was all finished. It’s nice to have a clean area to work in! My biggest challenge was all those pieces of scrap wood that I just might need “someday.” They burned well in my son’s woodstove. And I did get through all the patterns....
      Today, 10:54 PM
    • tgiro01
      Reply to First you need to make a mess
      by tgiro01
      Wow - Betty, what do you charge. I have things to do and I'm in the process of cleaning my shop, just to have room to do it. My problem is that I get the work bench cleared and then start working on projects again. I really need to do the workbench last.
      Today, 10:05 PM
    • tgiro01
      Reply to YoraHome Laser w/CNC Engraver/Router
      by tgiro01
      I ordered and received the ORTUR Laser Master 2 from Amazon, the but haven't had a chance to even get it out of the box. Too much going
      on right now. I got the 20 watt version, which is supposed to be good for cutting, but I don't think I'll be doing much of that. There will be a learning curve...
      Today, 09:57 PM
    • Linda In Phoenix
      Reply to Sue Mey's site
      by Linda In Phoenix
      Rick---if you are looking for a fretwork piece perhaps you could take 2 patterns and merge them into 1....
      Today, 09:16 PM
    Working...
    X