Hello, I am brand new to scrolling, I just got a Delta 20" saw and an intro pack of Flying Dutchman blades. #1,#3,#5,#7,#9 & #12. I think that should get me started.
Announcement
Collapse
No announcement yet.
New To Scrolling
Collapse
X
-
Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.
You may find the stickies at the top of this forum to be very helpful. Use the Link below.
Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.
Take a few minutes to read through them. They are chock full of great information.
Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.
Whatever reason brought you to our forum we are pleased you found us.
Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum."Still Montana Mike"
"Don't worry about old age--it doesn't last that long."
Mike's Wood-n-Things LLC
-
Welcome "a-board" elmsfordlt.........I echo Scroller3R about the 2/0 blades, my favorites too.
Come by often, lots of great stuff around here.Gloria ............... Two memorable things to say in life, "Hello" for the first time, and "Good-bye" for the last.
Comment
-
Welcome!
2/0 FD blades? I have never been able to follow a line with them.Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw Association
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to FInished Productby tgiro01It will sit on the coffee table for a couple of weeks/months - Until I finish the next one. Then it get relegated to the collection to await the next craft show. Or it may go to the art gallery for a few months.
Jim - Same two words I gave Rolf and Scott -- Wedgie Sled. Jerry Bennett's...-
Channel: Off Topic
Yesterday, 07:16 PM -
Comment