Hi, My name is Doug , I am just getting started in scroll sawing, which iI hope will become a fun new hobby.
Announcement
Collapse
No announcement yet.
Just getting
Collapse
X
-
Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.
You may find the stickies at the top of this forum to be very helpful. Use the Link below.
Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.
Take a few minutes to read through them. They are chock full of great information.
Be sure and share pics of your projects. We thrive on pictures.
The only dumb question is the one that remains unasked.
Whatever reason brought you to our forum we are pleased you found us.
Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum."Still Montana Mike"
"Don't worry about old age--it doesn't last that long."
Mike's Wood-n-Things LLC
-
Welcome to the forum Doug!Frieke
www.friewoodart.webs.com
Visit Frieke's gallery
Don't let the pain of your past and the fear of your future ruin the happiness of your present.
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to Spiral Blades - Tips & Tricks?Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
-
Channel: Tools and Blades
Today, 07:05 PM -
-
Reply to Eagleby Sandy OaksI agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
-
Channel: General Scroll Saw
Today, 12:00 PM -
-
Reply to Spiral Blades - Tips & Tricks?by RolfI have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...-
Channel: Tools and Blades
Today, 09:16 AM -
-
Reply to Spiral Blades - Tips & Tricks?by JimernThe best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
-
Channel: Tools and Blades
Today, 05:27 AM -
Comment