Announcement

Collapse
No announcement yet.

New Member

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • wood-n-things
    replied
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures.

    The only dumb question is the one that remains unasked.

    Whatever reason brought you to our forum we are pleased you found us.

    Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.

    Leave a comment:


  • 61mitch
    replied
    Thankyou Marshall, have only done silouhette pieces to start ( only Basic )

    Leave a comment:


  • marshall
    replied
    Andrew welcome and hope you enjoy the site , maybe later you can cut something and enter some of you projects for us all to see ...............MB

    Leave a comment:


  • 61mitch
    replied
    New Member

    Hi everyone, I'm Andrew and come from tamworth, Australia and just wanted to introduce myself.

    Leave a comment:


  • 61mitch
    started a topic New Member

    New Member

    Hi Everyone, I'm relatively new to scrollsawing since purchasing a secondhand scrollsaw at a garage sale to see if i liked, and am getting a lot of enjoyment.
    look forward to using this site

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • Jo Labre
    Reply to Joining the new tool frenzy
    by Jo Labre
    I cut a bunch of chakte viga and leopardwood pieces for the Viking project and the blade seems pretty good yet. I imagine if I were to only cut softer hardwoods (?) the blade would last quite a long time. Still - $25.00 is a lot more than the cost of standard scroll saw blades....
    Today, 02:36 PM
  • old fa_t
    Reply to Old,,,,but new here
    by old fa_t
    The room was supposed to be storage but it's my office? now with a roll top desk and a barristers bookcase.which I built when I was able.
    Today, 01:55 PM
  • Rolf
    Reply to Joining the new tool frenzy
    by Rolf
    Very nice! I really like your setup especially for the dust collection. I would have to figure out a way to re-weld the blade.
    And Oh to have wall space and organizational skills!
    Today, 09:55 AM
  • Rolf
    Reply to Old,,,,but new here
    by Rolf
    Welcome! As the others have said, lots of support and knowledge here ready to be shared.
    Is the 6 x10 your workspace or your entire apartment. ?
    Today, 09:34 AM
  • Rolf
    Reply to Log slice ornaments
    by Rolf
    Most of the cut outs were done with the scroll saw.
    Karl I have a couple of power carvers. The classic Dremel with a flex shaft I then bought a Ram Power carver, they both use 1/8 shank bits. I have a bunch of carbide cutters from when our Printed circuit board facility at work was dismantled....
    Today, 09:29 AM
Working...
X