Announcement

Collapse
No announcement yet.

New Member

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • New Member

    Hi Everyone, I'm relatively new to scrollsawing since purchasing a secondhand scrollsaw at a garage sale to see if i liked, and am getting a lot of enjoyment.
    look forward to using this site

  • #2
    New Member

    Hi everyone, I'm Andrew and come from tamworth, Australia and just wanted to introduce myself.

    Comment


    • #3
      Andrew welcome and hope you enjoy the site , maybe later you can cut something and enter some of you projects for us all to see ...............MB
      Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

      Comment


      • #4
        Thankyou Marshall, have only done silouhette pieces to start ( only Basic )

        Comment


        • #5
          Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.

          You may find the stickies at the top of this forum to be very helpful. Use the Link below.

          Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

          Take a few minutes to read through them. They are chock full of great information.

          Be sure and share pics of your projects. We thrive on pictures.

          The only dumb question is the one that remains unasked.

          Whatever reason brought you to our forum we are pleased you found us.

          Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.
          "Still Montana Mike"

          "Don't worry about old age--it doesn't last that long."
          Mike's Wood-n-Things LLC

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • NC Scroller
            Reply to My covid angel
            by NC Scroller
            I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
            Today, 07:27 AM
          • Quartz43
            Reply to Tough Decisions
            by Quartz43
            I understand supporting the magazine and agree. I just do not find many projects that fit my desires.

            I would like to see them do a poll with subscribers to find out what type projects people want to see....
            Today, 05:42 AM
          • GladeFade
            Reply to My covid angel
            by GladeFade
            First off how thick is the board you cut?
            When I want something to stand out I use backer-boards 1/8 thick to get the depth.
            that means you would have to cut the big cutting into pieces to put the spacer behind.
            for instance the cloud bottom right which his hand is on I would put maybe...
            Yesterday, 11:05 PM
          • Linda In Phoenix
            Reply to Wooden Headstone
            by Linda In Phoenix
            I am stunned at the fact it wasn't rotted or termite destroyed. That must've been one blessed lady. Thank you for what you all are doing!
            Yesterday, 10:43 PM
          • Linda In Phoenix
            Reply to Hard Woods for low $$$
            by Linda In Phoenix
            Pretty boards. Our Walmart didn't have any when I went. Thank you for sharing though.
            Yesterday, 10:41 PM
          Working...
          X