Announcement

Collapse
No announcement yet.

old, but new here

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • old, but new here

    Although I have read alot of posts and have learned so much, it has taken me a long time to join in...slow learner!!! I hope to learn a lot more and maybe even share some of my insights with others.

  • #2
    Welcome hobarth ..............it take time when scrolling and a lot of practice too.......
    Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

    Comment


    • #3
      Welcome to the forum! There are plenty of helpful people here if you have any questions and loads of great info if you dig around a little bit. Happy scrolling!
      Keith Fenton
      Scroll saw patterns @
      www.sheilalandrydesigns.com

      Comment


      • #4
        Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.

        You may find the stickies at the top of this forum to be very helpful. Use the Link below.

        Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

        Take a few minutes to read through them. They are chock full of great information.

        Be sure and share pics of your projects. We thrive on pictures.

        The only dumb question is the one that remains unasked.

        Whatever reason brought you to our forum we are pleased you found us.
        "Still Montana Mike"

        "Don't worry about old age--it doesn't last that long."
        Mike's Wood-n-Things LLC

        Comment


        • #5
          Welcome hobarth, get yourself buttoned up for a Maine winter, do some scrolling, and post pictures of your projects. We love pictures, as you may already know.....not mandatory to post them, but sure is appreciates.
          Gloria ............... Two memorable things to say in life, "Hello" for the first time, and "Good-bye" for the last.

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • Misouri Wayne
            Reply to Spiral Blades - Tips & Tricks?
            by Misouri Wayne
            Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
            Today, 07:05 PM
          • Sandy Oaks
            Reply to Eagle
            by Sandy Oaks
            I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
            Today, 12:00 PM
          • Rolf
            Reply to Spiral Blades - Tips & Tricks?
            by Rolf
            I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
            They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
            Today, 09:16 AM
          • Jimern
            Reply to Spiral Blades - Tips & Tricks?
            by Jimern
            The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
            Today, 05:27 AM
          • Linda In Phoenix
            Reply to Mexican Covid19 Vaccination logo - my version :)
            by Linda In Phoenix
            Go Wylie Coyote!!!
            Yesterday, 09:19 PM
          Working...
          X