Announcement

Collapse
No announcement yet.

asr

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • asr

    Hi everyone,
    I'm a beginner to scrollsawing and am looking to make some childrens names where the letters join like in a jigsaw and not sure how to do this.
    This has probably been asked before but I'd appreciate if someone could point me in the right direction. thanks in advance.
    Last edited by asr; 09-11-2011, 02:39 PM. Reason: wrong title

  • #2
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures.

    The only dumb question is the one that remains unasked.

    Whatever reason brought you to our forum we are pleased you found us.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment


    • #3
      Hi wood-n-things. Thanks for the reply. Not sure youd like to see my work just yet, a lot more practise needed!! Luckily picked up a cheap hegner with low mileage recently and just getting used to it aswell as gathering all the relevant info. but enjoying it a lot. many thanks

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Jim Lowder
        Reply to Question about tilting head saws
        by Jim Lowder
        Thank you everyone. I guess I just need to scroll more and have more patience with my abilities. You all are amazing...
        Yesterday, 08:08 PM
      • evilbadger
        Reply to Cutting Air
        by evilbadger
        How thick is that foam Randy? That turned out really nice.

        The view on the house is nice but that 11 foot 3 ceiling height is killing me....
        Yesterday, 07:56 PM
      • Rolf
        Reply to Question about tilting head saws
        by Rolf
        I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
        Regarding compound cuts they are cut at 90 degrees.

        If I were in the market for a new...
        Yesterday, 05:38 PM
      • handibunny
        Reply to Question about tilting head saws
        by handibunny
        If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. ๐Ÿ˜

        Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
        Yesterday, 05:09 PM
      • Jim Lowder
        Reply to Question about tilting head saws
        by Jim Lowder
        Thank you all for the info. Sounds like itโ€™s talent or practice issue not my saws. Wife already gave permission to buy a new one. I will wait tho
        Yesterday, 04:51 PM
      Working...
      X