If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Welcome to the forum Pablo, you're in the right place! You can find lots of info by browsing around and there are plenty of helpful people if you have any questions.
Welcome A Board Pablo!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions.
You may find the stickies at the top of this forum to be very helpful. Use the Link below.
Talked to him yesterday after he was coherent. Very fortunately, it was dc current. He said ac current and would have ended differently. And it wasn’t a house. It was a converter box in a marina located on a deck cut into a 20’ high steep bank. They had to climb a ladder to get to it. And they were...
Wow!!!! That is beautiful. Super job of sawing. If I worked it out correctly it took you less than a minute for each opening especially when I look at the amount of time it would take to saw the outline of the bear. Garry
Thanks guys, I have a lot of HDU left over from my sign business in various thicknesses.
HDU doesn't "fuse" or repair itself under heat or friction. Only acrylics and some PVC materials do that. Depending on what part of the world you are in, you would have to google HDU Distributors...
Comment