I have bought a delta scroll saw model ss250. I bought it on ebay. It arrived broken and the place I bought it from will not fix it. Its my problem. Does anybody have a broken one and would like to sell the motor. My saw is brand new and I need a motor. My address is [email protected] This is my first scroll saw and I would like to get started....Warren
Announcement
Collapse
No announcement yet.
delta ss250
Collapse
X
-
I sent you an email 28footer, I have a 2 speed motor but not the variable model.
I am not sure of shipping costs due to weight.
My first choice would be contacting Delta, for the nearest service center. If you don't have any luck just email me back. I am sure we can work something out.CAЯL HIRD-RUTTEЯ"proud member of the best scroll sawing forum on the net."Ryobi SC180VS scroll saw EX21
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
by RolfA family friends father passed away and he was an avid bird carver. So my nephew is helping the family sell some of his tools. I bought this air cleaner and will b uy most of his carving knives and burrs. And no that is not my workshop! Not even close. ...
-
Channel: Tools and Blades
Today, 04:47 PM -
-
by RolfI just did a quick job on my table. Charles Hand has noticed that the adhesive on the new rolls of Contact brand shelf paper leaves a residue. He has changed to The duck brand. I just bought a roll and covered my table with it. It is a tough slick surface. It will be interesting to see how it holds...
-
Channel: Tools and Blades
Today, 04:44 PM -
-
Reply to Shawl pinsby axor
Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...-
Channel: General Scroll Saw
Today, 03:21 PM -
-
by handibunnyRolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
-
Channel: Tools and Blades
Today, 09:21 AM -
-
by Bill WilsonI've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
-
Channel: Tools and Blades
Today, 09:06 AM -
Comment